The JA-110C PIR with photo camera is used to take photos of a monitored area and send them to the control panel of the JABLOTRON 100 security system.
Photo capture is activated either by activating a PG output, by a photo request from the MyJABLOTRON Web Self-Service, or by another detector (through PG activation). This setting is supplemented by an optional feature where photos are taken continuously and temporarily stored. They are later deleted if the detector is not triggered. If the detector is triggered at any time, a number of pre-activation photos are saved, and post-activation photos are also taken and stored in memory, with a predefined number of photos being taken during and after the detector is triggered. The camera is equipped with an infrared illuminator. The camera's ambient light sensor can activate a PG output in the system (which can be used, for example, to switch on an external IR illuminator). The camera is monitored and protected against tampering by a tilt detector. For outdoor use, where there is a risk of direct contact, an additional protective housing is recommended. The camera occupies one position in the system.
Specifications;
Power supply via the control panel bus 12 V (9 - 15 V)
Power consumption (idle/with additional IR illumination) 15 mA/150 mA
PIR detection angle of the camera 75°
Range of the additional IR illumination max. 12 meters
Camera resolution LQ 320x240; HQ 640x480 pixels
Environment according to EN 50131-1, IV. outdoor, general
Operating temperature range -20 to +60°C, max. humidity 75%
Ingress Protection Class IP65
Dimensions 155 x 75 x 55 mm
Classification level 2 In accordance with EN 50131-1, EN 50131-3
In accordance with EN 50130-4, EN 55022, EN 50581
