Jablotron fire, gas and carbon monoxide detectors
-
Jablotron Ei208W stand-alone CO detector
Jablotron Ei208W stand-alone CO detectorThis CO detector can be connected to the Jablotron 100 using: the JA-150G-CO module. The detector is certified for use in buildings, caravans and boats. The detector indicates excessive carbon monoxide concentration both optically with an LED and acoustically using a built-in siren.The detector is powered by an integrated lithium battery.Product Info
€165,06
-
Jablotron Ei208DW stand-alone CO detector with display
Ei208DW stand-alone CO detector with displayThis CO detector can be connected to the Jablotron 100 using: the JA-150G-CO module. The detector is certified for use in buildings, caravans and boats. The detector provides excessive carbon monoxide concentration both optically and acoustically with an LED and acoustic signal using a built-in siren. This model also shows the concentration data on the display.The detector is powered by an integrated lithium battery.Product Info
€218,91
-
Jablotron JA-110G-CO Connection module
Jablotron JA-110G-CO Connection module The Jablotron JA-110G-CO Connection Module is a plug-in module intended for direct installation in an autonomous Ei208W or Ei208DW CO detector, which allows the connection of the bus to the JABLOTRON 100 system. Product Info
€45,59
-
Jablotron GS-208-CO Connection module
Jablotron GS-208-CO Connection module The Jablotron GS-208-CO Connection Module is a plug-in module intended for direct integration into the autonomous Ei208W or Ei208DW CO detector, allowing the wired connection of the bus to a protection unit or other system.The module provides galvanic isolation of the wired output of the entire detector. It provides the control panel with information about alarms and detector faults. Product Info
€49,51
-
Jablotron JA-111ST-A BUS combined smoke and heat detector with fire and burglar siren
Jablotron JA-111ST-A BUS combined smoke and heat detector with fire and burglar siren functionThe product is used to detect fire hazards in the interior of residential and commercial buildings. The detector is not intended for installation in an industrial environment. The detector is powered via the control panel bus. When the detector is used with batteries (3x 1.5 V AA) from which it can be powered, it will continue to function as a standalone detector when the 12 V supply is disconnected (EN 14604).The smoke detector has a built-in siren that signals fire and burglar alarms. This message is accepted by all detectors in the system!The detector indicates fire danger using the built-in LED indicator and acoustic signaling.The JA-111ST-A product consists of two independent detectors – an optical smoke detector and a heat detector. The optical smoke detector works according to the principle of scattered light. It is very sensitive to coarser dust particles present in dense smoke. The product is less sensitive to smaller particles generated by combustion of liquids such as alcohol. That is why the fire detector also contains a built-in heat detector, which reacts more slowly, but is better able to detect a fire that generates only a small amount of smoke.Product Info
€123,81
-
Jablotron JA-110ST BUS combined smoke and heat detector
Jablotron JA-110ST BUS combined smoke and heat detectorThe Jablotron JA-110ST BUS combined smoke and heat detector detects fire inside a building. The detector has different settings, such as: smoke and heat, smoke or heat, smoke only or heat only. It has an alarm memory function where the LED will still be on after the alarm status has passed. It is possible to assign the detector to a zone and it only occupies one position in the alarm system. SMART MEMORY indication (SMI) provides visual LED verification of an activated detector. SMI can be switched off using the code control panel.Product Info
€103,38
