Jablotron accessories
-
Jablotron JA-110Z-B BUS connection module
Jablotron JA-110Z-B BUS connection moduleThe Jablotron JA-110Z-B BUS connection module is designed to join BUS wires in the JA-100 system and can be installed in the JA-190PL housing.Product Info
€12,37
-
Jablotron AC-160-DIN Multifunction relay
Jablotron AC-160-DIN Multifunctional relay The Wireless AC-160-DIN Multifunction Relay is a component of the JABLOTRON 100 system, but can also be installed as a stand-alone device without linking to a control panel.It offers a switching contact relay with galvanic isolation and safety for switching 230 V / 16 A current loads. The relay can respond to the status of control panel PG outputs or for the activation of devices of the JA-15x series with uni-directional communication, read directly into the relay. The response can be selected from five modes - the standard NATURAL function (extended copy), IMPULSE, STATUS CHANGE, SWITCH OFF and BLOCK. The relay also has a button for immediate manual status change. Allows you to update the firmware via a USB port. It is designed to be mounted on a DIN rail.
€165,06
-
Jablotron JA-110Z Connection module
Jablotron JA-110Z Connection module The Jablotron JA-110Z Connection Module is designed for branching the bus of the JABLOTRON 100 system. It is protected from attack by a pair of tamper contacts. It is supplied in a suitable flush-mounted box JA-190PL.The contact module also contains 2x4 terminal boards, which are connected in parallel and allow independent branches to be interconnected. He occupies one position in the system.
€45,59
-
Jablotron JA-191PL Wall bracket and ceiling bracket for design detectors
Jablotron JA-191PL Wall mount and ceiling mount for design detectorsThe Jablotron JA-191PL Wall bracket and ceiling bracket can be used for various design detectors of the JA-100 system.
€16,13
-
Jablotron JA-193PL-F-M-W, white frame for mounting box wireless Designline PIR
Jablotron JA-193PL-F-M-W, white frame for mounting box wireless Designline PIRJA-193PL-F-M-W, white frame for mounting box wireless Designline PIR
€3,93
-
Jablotron AN-868-2PIN External antenna
Jablotron AN-868-2PIN External antenna The external antenna AN-868 is used to extend the communication range of wireless components of Jablotron security systems, which operate on the frequency of 868 MHz.A special construction of the PIFA type not only guarantees very good transmission properties on different substrates, but also serves as tamper detection in the event of an interruption or short circuit in the power supply (this functionality must be supported by the connected component). The antenna can be mounted indoors or outdoors.The AN-868-2PIN version is connected via a 2-pin connector, which is used with the elements of older systems and the existing elements of the JABLOTRON 100 system.
€66,02
-
Jablotron UR-01 Multifunctional relay
Jablotron UR-01 Multifunctional relay You can store the Jablotron UR-01 Multifunction Relay in your tool bag to help you solve many tasks.It is equipped with switching contacts with galvanic and safety isolation for switching a load of 230VAC/16A, which can be used in one of eight selectable modes. The relay is designed for mounting on a DIN rail and its characteristics are set using switches under a cover.It offers 8 functions:* Switching relay – Standard NO/NC relay* Bistable relay – for example for lighting control from multiple locations using buttons* Bistable relay with time limitation – for example to control lights from multiple places (however the light will not be on for longer than the set time)* Delayed shutdown - for example for fan run-off* Delayed start – starting an electric motor in star - delta mode.* Impulse through leading edge – activation of a device for a certain time* Impulse via rear flank – for example to switch on a fan after switching off the lights* Regular impulses – at a fixed interval this will activate a device for a period of 10 minutes - for example for the regular heating of a heating element in the bathroom
€130,92
-
Jablotron CC-02 Installation cable for the JA-100 system
Jablotron CC-02 Installation cable for the JA-100 systemThe Jablotron CC-02 Installation cable for the JA-100 system is designed for easy installation. The colors of the cables are identical to the colors of the terminals. 300 meters of cable and each meter marked in black.2 x 2 x 24 AWG (0.5 mm) max. Conductor DC resistance 20 °C 97 O/km
€247,59
-
Jablotron AC-160-C wireless multi-function power relay, built-in model
Jablotron AC-160-C wireless multifunctional power relay, built-in modelThe relay can also be installed as a standalone device, responding to the activation of, for example, unidirectional wireless detectors of the JA-15x series. In this case, the relay is activated according to the mode selected for the respective detector (choice of 5 modes: extended copy, impulse, status change, shutdown and blocking). It provides a switching contact relay with galvanic and safety isolation for switching a current load of 230V/16A. He occupies one position in the system. Nominal supply voltage 100-230 V, 50-60 HzInternal energy consumption at 230 V AC (min / max) 0.2 W / 0.7 WOperating frequency 868.1 MHz, Jablotron protocolAntenna internalContact load capacity – protection class II Max. switched voltage 250 V ACResistive load (cosφ=1) max. 16 A Inductive, capacitive load (cosφ=0.4) max. 8 AHalogen lighting max. 1000 W Minimum switching DC power supply 0.5 WDiameter of the connected conductors max. 2 x 1.5 mm2; max. 1 x 2.5 mm2Ingress protection class IP20Dimensions 49 x 49 x 26 mmOperating temperature range -10 °C - + 40 °C, RH 75% non-condensingIn accordance with ETSI EN 300 220-1, EN 50130-4, EN 55022, EN 60950-1Operating conditions ERC REC 70-03
€152,90
-
Jablotron JA-110N-DIN BUS DIN current output power module
Jablotron JA-110N-DIN BUS DIN current output power moduleThe Jablotron JA-110N-DIN BUS DIN current output power module is designed for a DIN rail. The module supplies power to the relay output. It can be used, for example, to control lights, fans, etc. The relay output is programmable via the control panel.• Power supply 12 V bus (9 ... 15 V)• Power consumption during backup (relay open / closed) 5 mA / 45 mA• Power consumption for cable selection 45 mA• Rating relay (galvanically isolated) - Class II:• Maximum switching voltage 250 V AC / 24 V DC• Resistive load (PF = 1) max.16• Inductive, capacitive load (PF = 0.4) max 8A• Halogen lighting max. 1000 W DC 384 W• Minimum DC switching 0.5W• Twisted wires 2 x 1.5 mm2 max 1 x 2.5 mm2• Dimensions 18 x 90 x 64 mm• General indoor environment• Temperature, -10 To + 40 ° C• Housing IP-20• Complies with EN 50130-4, EN 55022, EN 60950-1 DIN rail EN60715
€119,89
-
Jablotron JA-114HN BUS connection module with 4 inputs and outputs
Jablotron JA-114HN BUS connection module with 4 inputs and outputsA bus module, containing four wired inputs with adjustable EOL resistance values, four galvanically isolated signal PG outputs and an additional power supply, protected by an electronic fuse. In addition to the EOL type resistor, the values of resistors can also be set for the inputs. The outputs are designed as galvanically isolated units (two each have a common C terminal). The module occupies four positions in the control panel and is equipped with one tamper sensor at the front and one at the back.It is especially suitable for the renewal of wired alarms, where old detectors are used. They are also very commonly used to control multiple devices through the PG outputs. The auxiliary power supply makes it possible
€202,41
-
Jablotron JA-193PL-F-M-G, gray frame for mounting box wireless Designline PIR
Jablotron JA-193PL-F-M-G, gray frame for mounting box wireless Designline PIRJA-193PL-F-M-G, gray frame for mounting box wireless Designline PIR
€3,93
-
Jablotron AN-868 External antenna
Jablotron AN-868 External antenna The external antenna AN-868 is used to extend the communication range of wireless components of Jablotron security systems, which operate on the frequency of 868 MHz.A special construction of the PIFA type not only guarantees very good transmission properties on different substrates, but also serves as tamper detection in the event of an interruption or short circuit in the power supply (this functionality must be supported by the connected component). The antenna can be mounted indoors or outdoors.The AN-868 version is connected via a 3-pin connector, which is used in the newly developed components of the JABLOTRON 100 system.
€66,02
-
Jablotron JA-190X PSTN communication module
Jablotron JA-190X PSTN communication moduleThe JA-190X is a PSTN communication module for the JA-106KR. The module offers the option of Contact ID DTMF, SIA DC-05 or SIA FSK with standard DC-03 protocol for control room communication and/or voice messages.Remotely access the system through the PSTN telephone lineAccording to the settings of the central unit by F-Link software, i.e. the Communication / Voice menu and the control SMS tabs, when you call the system from any / authorized phone the system will answer your call and ask you to enter your valid code. The communicator offers options with your voice. The structure of the voice menu changes with the restriction level of inputcode.If a new event occurs in the system, the call will be terminated.
€128,11
-
Jablotron JA-192Y GSM dialer for Jablotron Pro Centrales
Jablotron JA-192Y GSM dialer for Jablotron Pro Centrales The control panel equipped with a JA-192Y communicates via a mobile network with a central monitoring station, enables control and mobile applications via the web and sends alarm SMS messages and voice messages. This allows the system to be set up remotely using the settings of the F-Link program.
€288,86
-
Jablotron CT-01 Roller shutter detector
Jablotron CT-01 Roller shutter detector The CT-01 is a wired detector intended for detecting the unauthorized movement of external shutters on houses or buildings. This detector is hardwired and can be connected with JA-150M or JA-81M to continue communication wirelessly.By using this detector it is possible to optimally protect the building against intruders. When the shutters are forced, this will be detected and the alarm can respond. Even before the intruder gets in! False alarms caused by the wind, which causes the shutters to move only slightly, are avoided because the alarm only occurs when at least 3 pulses are received within 5 seconds.Product Info
€45,59
-
Hikvision Dummy security camera dome model, metal housing, original Hikvision
Hikvision Dummy security camera dome model, metal housing, original HikvisionThe outdoor dummy camera helps to deter intruders. This is a real Hikvision Dome Camera, but it is a defective model that is very suitable as a dummy. The camera has a metal housing and is approximately 11 cm in diameter and 8 cm high.
€34,90
-
AlarmsysteemExpert.nl Power cable | Euro plug - Open cable end | 2.0m | Black
Power cable | Euro plug - Open cable end | 2.0m | BlackProduct descriptionDo not throw away an electrical appliance if only the strip cable is broken. Replace it with this Nedis® Euro power cable. The cable is a perfect spare part for devices that are not grounded, such as televisions and speakers.Properties• Max. capacity is 6 A• Ungrounded cable• Euro plug
€3,50
-
Jablotron JA-110Z-D Multipositional bus contact module
Jablotron JA-110Z-D Multipositional bus contact module This module is designed to connect the conductors of complex bus installations of the JABLOTRON 100 system. It can be divided into two independent bus branches by disconnecting jumpers.It can be installed in the junction box JA-194PL, PLV-CP-M / L or directly in the central JA-106K.Product Info
€33,01
-
Nedis Dummy security camera Dome IP44 White
The indoor dummy camera helps to deter intruders. It has a professional design with a built-in flashing LED, and is easy to mount with the included bracket.Specifications: Battery type 2xAA/R6 Camera design Dome Feature Plastic Housing IP rating IP44 Color White Package contents: 1x dummy camera1 x installation materialManual
€23,90
-
Jablotron TRF-01A-C transformer for JA-82 and JA-100/101 control panel
Jablotron TRF-01A-C transformer for JA-82 and JA-100/101 central
€25,00
-
Jablotron JB-110N Pro Bus PG power output module
Jablotron JB-110N Pro Bus PG power output module The product is a system device for the Jablotron Midway Pro and Essex Pro. It provides a switching contact for the output power relay. For example, it can be used to control lighting, fans, etc. The relay communicates via the bus and is powered by the control panel bus. It can be installed in a JA-19xPL installation box or a control box.
€82,53
-
Nedis Anti-climb strip Set of 10 pieces Warning sticker included
Attach this anti-climb strip to a wall, fence or gate and protect yourself against unwanted visitors. The anti-climb strip deters burglars, but is also very effective against cats, birds and other animals that like to climb over or sit on your fence. Including warning sign; In some regions the use of warning signs is legally required.Specifications: Content 10 pcs Length 450mm Color Gray Material Plastic Package contents: 10x anti-climb stripWarning sign with stickers
€18,00
-
Nedis TV Simulator Built-in timer Black
This TV simulator produces a light that looks exactly like a real television. This way it looks like you're at home, even when you're not.This realistic effect can be turned on automatically with a timer that records the sunset.When the simulator is in use, it fills the room with bright light in different shades and shades. This imitates a television, which deters burglars from entering your home.Due to its low power consumption, this simulator offers an environmentally friendly but highly effective alternative to other security options.
€14,90
You have 48 of the 67 products seen